The datasheet of the Expansion Board is available as a PDF File.
The pinout of the Expansion Board is available as a PDF File
The Expansion Board features a single cell Li-Ion/Li-Po charger. When the board is being powered via the micro USB connector, the Expansion Board will charge the battery (if connected). When the
CHG jumper is present the battery will be charged at
450mA. If this value is too high for your application, removing the jumper lowers the charge current to
The FTDI chip as been replaced with a custom programmed PIC like on the
Pysense/Pytrack/Pyscan boards. This allows our firmware update tool to
automatically put the module into bootloader mode.
Added a "Safe boot" button to enter safe boot easier. This button connects
3.3v and if pressed and held while the reset button is pressed on
a Pycom module, the module will enter safe boot.
If PIC stays in bootloader mode, the
dfu-util update should be performed